20 mm field straps are compatible with Misfit Phase, Command and Vapor (heart rate disabled). The NATO strap covers up the back of Vapor, which blocks the heart rate sensor. If you are using a Misfit Vapor or Command device, you will need a 20 mm spring bar pre-installed on the lugs of your device. If you are using a Misfit Phase device, you do not need a spring bar.
The images below depict how to use NATO straps on a Misfit Command device, but the same instructions would also apply to Misfit Phase and Vapor.
To use NATO straps:
![]() |
![]() |
![]() |
![]() |
If you are using a Misfit Vapor or Command device, 20 mm spring bars must be installed on the lugs of your device. | Pull up on the long strap material in the center of the NATO strap. | Continue pulling up on the strap material until it’s completely out from under the metal strap keeper. |
![]() |
![]() |
![]() |
![]() |
Insert the long strap material over the spring bar and behind the device. | Pull the end of the long strap material behind the device and over the second spring bar. Pull the strap material through as far as possible. | Slide the end of the long strap back under the metal strap keeper. |
![]() |
![]() |
![]() |
![]() |
Pull the long strap through the metal strap keeper as far as possible. |
Side view of properly installed field band. |
Comments
0 comments
Please sign in to leave a comment.